LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2003 >> LS 430 >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Systems >> Circuit Tests >> Stop Light Circuit >> Inspection Procedure

Inspection Procedure

  1. Connect the LEXUS hand-held tester to the DLC3. See Figure. Check the stop light switch using ACTIVE TEST. If the results are OK, proceed to the next circuit inspection of the problem symptom. See PROBLEM SYMPTOM INDEX (BODY NO. 4 CONTROL SYSTEM)  table. If the results are not good, go to the next step.
  2. Check the stop light bulb. If the results are OK, go to the next step. If the results are not good, replace the failure light bulb.
  3. Check the wiring harness and connector between the stop light and luggage room junction block (body No. 4) ECU, battery and stop light. See WIRING DIAGRAMS . If the results are OK, proceed to the next circuit inspection of the problem symptom. See PROBLEM SYMPTOM INDEX (BODY NO. 4 CONTROL SYSTEM)  table. If the results are not good, repair or replace the wiring harness or connector.
scientia non olet · About LEMON Manuals