Combination Meter: Notes
- Engine Coolant Temperature Gauge - The gauge indicates the engine coolant temperature when the ignition switch is on. The engine operating temperature will vary with changes in weather and engine load.
- Fuel Gauge - The gauge is displayed when the ignition switch is on and indicates the approximate quantity of the fuel remaining in the tank.
- Momentary Fuel Consumption Meter - The momentary fuel consumption is calculated and indicated based on the driving distance and the fuel consumption with the engine running.
- Tachometer - The tachometer indicates engine speed in thousands of RPM (revolutions per minute). Use it while driving to prevent engine over-revving.
- Voltmeter - The voltmeter tells whether the battery is charged or discharged. Check it while the engine is running, the needle should always indicate between 9-18 volts. If the needle reads below or above the normal range while the engine is running, it indicates that the charging system needs immediate repair. However, it is normal for the needle to drop below the normal range during engine starting.
- Odometer & Trip Meter - This meter displays the odometer and 2 trip meters. To change the mode indication, push the ODO/TRIP knob in order from the odometer to trip meter "A" to trip meter "B", then back to the odometer, etc. The odometer records the total distance the vehicle has been driven. The twin trip meter records 2 different distances independently. To set trip meter "A" to zero, display the "A" meter reading, push the knob and hold it. The same applies for the "B" trip meter. The data of trip meters will be cancelled if the electrical power source is disconnected.