Brake Actuator
WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove reservoir cap.
- Install special tool (09992-00242/00350) to reservoir. See Fig 1.
- Connect vinyl tube to bleeder screw of brake actuator. Using special tool (09992-00242/00350), apply a pressure of 14.2 psi (98.1 kpa) to reservoir.
- Loosen bleeder screw. Bleed air from brake actuator. Tighten bleeder screw to specification. See TORQUE SPECIFICATIONS .
- Check fluid level and fill if necessary.