Manual Shift Test
NOTE:
Perform manual shift test if no DTCs exist. Manual shift test determines if problem area is in electrical circuits or a mechanical transmission problem.
- With ignition off, disconnect electrical connector for solenoids from transmission. Road test vehicle and ensure transmission gear changes correspond with gearshift lever position. See GEAR APPLICATION table.
- If abnormality exists, a mechanical transmission problem exists. Turn ignition off. Reconnect electrical connector. Clear DTCs from ECM memory, as disconnecting electrical connector may set a DTC. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM.
GEAR APPLICATION
| Shift Lever Position | Gear |
|---|---|
| "D" | Overdrive |
| "2" | 3rd |
| "L" | 1st |
| "R" | Reverse |
| "P" | Park |