Inspection Procedure
NOTE:
If there is not the LEXUS hand-held tester, begin with STEP 2.
- Perform active test.
- PREPARATION: Connect the LEXUS hand-held tester to the DLC3.
- CHECK:
- Enter ACTIVE TEST function of the LEXUS hand-held tester.
- Check that the probe moves as the LEXUS hand-held tester directs in each range.
- OK: The meter operates normally.
- OK: Proceed to next circuit inspection shown on problem symptom table (See PROBLEM SYMPTOMS TABLES ).
- NG: Go to next step.
- Check speedometer (See COMBINATION METER - LS 430
article).
- NG: Replace speedometer.
- OK: Go to next step.
- Check circuit plate (See COMBINATION METER - LS 430
article).
- NG: Replace circuit plate.
- OK: Check and replace combination meter.