Inspection Procedure
NOTE:
In case of using the LEXUS hand-held tester, start the inspection from step 1 and in case of not using the LEXUS hand-held tester, start from step 2.
- Check headrest limit switch using LEXUS hand-held tester.
- PREPARATION: Connect the LEXUS hand-held tester to the DLC3.
- CHECK: Check the headrest limit switch using DATA LIST.
- OK: Proceed to next circuit inspection shown on problem symptom table (See PROBLEM SYMPTOMS TABLE ).
- NG: Go to next step.
- Check headrest limit switch (See INSPECTION
in Power Seat Control System - LS 430 article).
- NG: Replace limit switch.
- OK: Go to next step.
- Check harness and connector between rear LH seat ECU and limit switch, limit switch and body ground.
- OK: Repair or replace harness or connector.
- NG: Proceed to next circuit inspection shown in problem symptoms table.