Inspection Procedure
- Check MAP DISC visually.
- NG:
Replace MAP DISC.
- OK:
Go to next step.
- Insert MAP DISC without tilt.
- OK:
Normal.
- NG:
Go to next step.
- Check navigation ECU.
- PREPARATION:
Disconnect the navigation ECU connector.
- CHECK:
Check the voltage of terminal +B.
- OK:
+B: 10-14 V
- CHECK:
Check the voltage of terminal ACC when the ignition switch is in ACC or ON position.
- OK:
ACC: 10-14 V
- CHECK:
Check continuity at terminal GND.
- OK:
GND: Continuity
- NG:
Replace or repair wire harness or connector.
- OK:
Replace navigation ECU.