Inspection Procedure

WARNING: This page is about a different car, the 2004 Lexus GS 430 and 2004 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

In case of using the hand-held tester, start the inspection from step 1 and in case of not using the hand held tester, start from step 2.

Check door unlock detection switch using hand-held tester.
PREPARATION:

Connect the hand-held tester to the DLC 3.

CHECK:

Check the door unlock detection switch using DATA LIST.
1. OK: Proceed to next circuit inspection shown on problem symptom table. (See PROBLEM SYMPTOMS TABLE )
2. NG: Go to Next Step
Check door unlock detraction switch. (See INSPECTION )
1. NG: Replace the door lock motor.
2. OK: Go to Next Step
Check wire harness and connector between door unlock detection switch and driver door ECU.
1. NG: Repair or replace wire harness or connector.
2. OK: Go to next step.
  Proceed to next circuit inspection shown on problem symptoms table. (See PROBLEM SYMPTOMS TABLE )