LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2000 >> LX 470 >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Active Height Control & Adaptive Variable Suspension >> Component Tests >> Pressure Value Of Rear Shock Absorber >> Using Scan Tool

Using Scan Tool

  1. Connect hand-held tester to (DLC3). See Figure.
  2. Disconnect fluid temperature sensor harness connector.
  3. Start engine and push height select switch to adjust vehicle height from "N" to "LO" then back to "N" position.
  4. Stop engine and read pressure value of rear shock absorber with hand-held tester. Pressure should be 811-967 PSI (5592-6667 kPa). If pressure is not within specified range, it may be that a load object is either installed or removed.
  5. Check DTC. See SELF-DIAGNOSTIC SYSTEM . If a DTC is displayed, clear DTC. See SELF-DIAGNOSTIC SYSTEM .
  6. Start engine and push height select switch to adjust vehicle height to "LO" then to "N" position. Check that wheels are raised simultaneously.
scientia non olet · About LEMON Manuals