Diagnostic Procedure

Turn ignition on. Check voltage between terminals Ts and E₁ of DLC1. If voltage reading is 10-14 volts, circuit is okay. If ABS warning light does not blink even after terminals are connected, malfunction may exist in ABS/BA/TRAC/VSC ECU. If voltage reading is not 10-14 volts, check for open or short circuit in wiring harness between ABS/BA/TRAC/VSC ECU and DLC1, or between ground and DLC1. See WIRING DIAGRAMS . Repair as necessary. If wiring harness is okay, replace ABS/BA/TRAC/VSC ECU.