LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2000 >> LX 470 >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> Using CRUISE Indicator Light

Using CRUISE Indicator Light

  1. Locate Data Link Connector (DLC) No. 1 on right side of engine compartment, near air filter housing. See Figure. Turn ignition switch to ON position. Turn cruise control main switch on. If CRUISE indicator light turns on, leave ignition on and go to next step. If CRUISE indicator light does not turn on, check cruise indicator light circuit. See CRUISE CONTROL INDICATOR LIGHT CIRCUIT  under SYSTEM TESTS.
  2. Turn cruise control main switch off. Connect a jumper wire between terminals E1 and Tc at DLC No. 1. See Figure. If any DTCs are present, perform appropriate DTC test under DIAGNOSTIC TESTS . See DIAGNOSTIC TROUBLE CODE DEFINITIONS  table.
  3. If no codes are present and CRUISE indicator light begins flashing on and off every .25 second, system is operating normally at this time. If no codes are present and cruise control system fault still exists, perform SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
scientia non olet · About LEMON Manuals