Washer Motor Circuit

Disconnect washer motor 3-pin connector. Turn ignition on. Using a voltmeter, measure voltage between ground and terminal No. 2 (Blue wire). See WIRING DIAGRAMS . If battery voltage exists, check washer motor. See WASHER MOTOR under COMPONENT TESTS in appropriate WIPER/WASHER SYSTEMS article. Replace washer motor as necessary. Retest system operation. If battery voltage does not exist, check wire harness, connectors and 20-amp WASHER fuse located in instrument panel junction block, under left side of instrument panel. Repair or replace as necessary. Retest system operation.