Telltale Light Assembly Circuits
Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Check for continuity between terminals at 10-pin telltale light assembly harness connector. See Fig 1. Ensure continuity is as specified at appropriate terminals. See TELLTALE LIGHT ASSEMBLY CONTINUITY table. If continuity is not as specified, replace telltale light assembly.
TELLTALE LIGHT ASSEMBLY CONTINUITY
| Switch Position | Terminals No. | Continuity | |
|---|---|---|---|
| ODO/TRIP | |||
| Released | 3 & 10 | No | |
| Pressed | 3 & 10 | Yes | |
| RESET | |||
| Released | 8 & 10 | No | |
| Pressed | 8 & 10 | Yes | |
| Turn Signal | |||
| Right | 4 & 10 | Yes | |
| Left | 9 & 10 | Yes | |