Continuity Test

Disconnect 18-pin combination (wiper/washer) switch connector. Check for continuity between specified wiper/washer switch terminals with switch in specified position. See WIPER/WASHER SWITCH CONTINUITY table. See Fig 1. If continuity is not as specified, replace combination (wiper/washer) switch.

WIPER/WASHER SWITCH CONTINUITY

Switch Position

Check Continuity Between Terminals No.

Wiper Off

Mist Off ⁽¹⁾

7 & 16

Mist On ⁽²⁾

7 & 17

Wiper Intermittent

Mist Off ⁽¹⁾

2 & 4; 7 & 16

Mist On ⁽²⁾

2 & 4; 7 & 17

Wiper Low

7 & 17

Wiper High

1 & 2; 8 & 17

Washer

Off

⁽³⁾

2 & 11

⁽¹⁾	Lever in normal position.

⁽²⁾	Pull lever forward.

⁽³⁾	No continuity between terminals No. 2 and 11.

Fig 1: Identifying Combination (Wiper/Washer) Switch Terminals