NORMAL Mode Code Retrieval
- Connect scan tool to Data Link Connector (DLC) No. 3. See Fig 1. DLC No. 3 is located under left side of instrument panel. Turn ignition on with engine off. Turn scan tool on. Using scan tool manufacturer's instructions, check for DTCs and freeze-frame data.
- If scan tool displays UNABLE TO CONNECT TO VEHICLE, DLC No. 3 must be checked. See DLC NO. 3 INSPECTION under SCAN TOOL PROBLEMS. If scan tool does not display UNABLE TO CONNECT TO VEHICLE, go to next step.
- Record any DTCs and freeze-frame data displayed for system diagnosis. If driveability problem exists and no DTCs are present, go to appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
- If any DTCs are present, perform appropriate circuit test in DIAGNOSTIC TESTS . See DIAGNOSTIC TROUBLE CODES IDENTIFICATION table.
- After repairs for DTC have been completed, DTCs must be cleared from ECU memory. See CLEARING DIAGNOSTIC TROUBLE CODES .
DIAGNOSTIC TROUBLE CODES IDENTIFICATION
| DTC |
Probable Cause |
| P0500 |
Vehicle Speed Sensor |
| P0710 |
ATF Temperature Sensor |
| P0715 |
OD Direct Clutch Speed Sensor |
| P0750 |
No. 1 Solenoid |
| P0753 |
No. 1 Solenoid Circuit |
| P0755 |
No. 2 Solenoid |
| P0758 |
No. 2 Solenoid Circuit |
| P0760 |
No. 3 Solenoid |
| P0763 |
No. 3 Solenoid Circuit |
| P0768 |
No. 4 Solenoid Circuit |
| P0770 |
Lock-Up Solenoid |
| P1520 |
Brakelight Switch Circuit |
| P1755 |
Lock-Up Solenoid Circuit |
| P1760 |
SLT Solenoid Circuit |
| P1765 |
SLN Solenoid Circuit |
| P1780 |
Park/Neutral Position Switch |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002