LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 1996 >> SC 400 >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Electronic Power Steering >> Testing >> Component Test >> Power Steering ECU

Power Steering ECU

  1. Raise and support vehicle. Remove instrument panel undercover. DO NOT  disconnect ECU connector. Start engine. Using DVOM, measure voltage between ECU harness connector terminals SOL (+) and SOL (-) with engine idling. See Figure. DVOM should indicate .32-.44 volt.
  2. Place transmission in gear. Increase indicated vehicle speed to 37 MPH. DVOM should now indicate .14-.40 volt. If voltage is not as specified, replace ECU.
CAUTION: To avoid damage to solenoid, DO NOT  apply voltage for more than 30 seconds.
scientia non olet · About LEMON Manuals