Continuity Test
Disconnect combination switch connectors. Check for continuity between specified terminals. See Fig 1. See appropriate WIPER/WASHER SWITCH CONTINUITY table. If continuity is not as specified, replace combination switch.
WIPER/WASHER SWITCH CONTINUITY
| Switch Position | Continuity Between Terminals: | |||
|---|---|---|---|---|
| Wiper Off | A1 & A10 | |||
| Wiper Intermittent | A1 & A10; B5 & B6 | |||
| Wiper Low | A1 & B14 | |||
| Wiper High | B6 & B12; B7 & B14 | |||
| Washer On | B6 & B13 | |||
| Concealment Switch | ||||
| FULL | (1)* | |||
| SEMI | B6 & B11 | |||
|
||||