LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 1994 >> SC 400 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Emission Systems & Sub-Systems >> Exhaust Gas RECIRCULATION (EGR) Valve >> Calif. (Resistance Test)

Calif. (Resistance Test)

Disconnect EGR valve connector. See COMPONENT LOCATIONS  under INTRODUCTION. Measure resistance between terminal B1 and terminals S1-S4, and between terminal B2 and terminals S1-S4. See Figure. If resistance is not 19.9-23.4 ohms, replace EGR valve. If resistance is 19.9-23.4 ohms, check EGR valve operation.

CAUTION: When checking EGR valve operation, DO NOT apply battery voltage across terminals for more than a few seconds. Read the following procedure before performing it, as it contains a grounding sequence that must be followed exactly as specified.
scientia non olet · About LEMON Manuals