LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 1994 >> GS 300 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L 6-CYL >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

  1. To install, reverse removal procedure. Ensure transmission crossmember is installed with front mark (L6 V8) facing front of vehicle. Front mark is stamped on top of crossmember and should be positioned on driver's side of vehicle. Ensure front mark is facing upward (toward body).
    CAUTION: Install drive shaft center bearing so bracket on center bearing is parallel to drive shaft.
  2. Before installing drive shaft, apply grease to center bushing located in companion flange on drive shaft. Ensure reference marks on drive shaft companion flanges are aligned.
  3. Install NEW nuts when installing exhaust pipe components. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Adjust fluid levels, control cables and shift linkage (if necessary).
scientia non olet · About LEMON Manuals