LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 1990 >> ES 250 Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal & Installation >> Sensor Rotors >> Removal (Front)

Removal (Front)

  1. Raise and support vehicle. Remove wheels and tires. Remove drive axle shaft cotter pin and lock nut cap. Before removing disc brake caliper, loosen bearing lock nut while an assistant steps on brake pedal. Remove rotor attaching bolts. Remove disc brake caliper from steering knuckle. Suspend caliper aside with wire. Place match marks on disc and hub for installation reference. Remove brake disc from hub.
  2. Remove ABS speed sensor from steering knuckle. Remove 2 lower bolts, and disconnect steering knuckle. Remove cotter pin and nut. Using Ball Joint Puller (09628-62011), disconnect tie rod end from steering knuckle. Remove steering knuckle.
  3. Wrap drive shaft boot with cloth to protect from damage. Using a plastic-faced hammer, tap axle shaft and remove steering knuckle. Place knuckle in a soft-jawed vise. Remove inner grease seal. Remove bearing snap ring from knuckle.
  4. Remove 3 brake dust shield bolts. Remove dust cover. Using Universal Puller (09950-20017), remove axle hub from knuckle. Remove inner bearing race from bearing. Using a Torx (T30), remove speed sensor rotor mounting screws. Remove speed sensor rotor from axle hub.
scientia non olet · About LEMON Manuals