Pinpoint Test G: Steering Wheel (Module And Lin) Open Circuit Tests

G1: STEERING WHEEL (MODULE AND LIN) OPEN CIRCUIT TEST 1
1. Refer to the appropriate service information and remove the driver airbag DRIVER AIRBAG MODULE
2. Check the integrity of the wiring harness (clockspring to steering wheel heater control module)
  Is a wiring harness fault present?
  
  Yes: Repair the harness as necessary
  
  No: GO to G2.
G2: STEERING WHEEL (MODULE AND LIN) OPEN CIRCUIT TEST 2
WARNING: Do not probe or disconnect the airbag connector(s) during this test.

NOTE: Rotate the steering wheel during this test to check for an intermittent fault.
1. Disconnect clockspring connector C2R115B
2. Disconnect clockspring connector C2LS41H
3. Set a multimeter to measure resistance
4. Connect the multimeter to clockspring connector C2R115B terminal 4 and clockspring connector C2LS41H terminal 7
  Does the multimeter display > 0 ohms?
  
  Yes: Install a new clockspring
  
  No: GO to G3.
G3: STEERING WHEEL (MODULE AND LIN) OPEN CIRCUIT TEST 3
WARNING: Do not probe or disconnect the airbag connector(s) during this test.

NOTE: Rotate the steering wheel during this test to check for an intermittent fault.
1. Connect the multimeter to clockspring connector C2R115B terminal 1 and clockspring connector C2LS41H terminal 8
  Does the multimeter display > 0 ohms?
  
  Yes: Install a new clockspring
  
  No: GO to G4.
G4: STEERING WHEEL (MODULE AND LIN) OPEN CIRCUIT TEST 4
WARNING: Do not probe or disconnect the airbag connector(s) during this test.

NOTE: Rotate the steering wheel during this test to check for an intermittent fault.
1. Connect the multimeter to clockspring connector C2R115B terminal 2 and clockspring connector C2LS41H terminal 4
  Does the multimeter display > 0 ohms?
  
  Yes: Install a new clockspring
  
  No: Install a new steering wheel heater control module