Pinpoint Test F: Steering Wheel (Lin) Short Circuit Tests
- F1: STEERING WHEEL (LIN) SHORT CIRCUIT TEST 1
- Refer to the appropriate service information and remove the driver airbag DRIVER AIRBAG MODULE
- Check the integrity of the wiring harness (clockspring to steering wheel heater control module)
Is a wiring harness fault present?
Yes: Repair the harness as necessary
No: GO to F2.
- F2: STEERING WHEEL (LIN) SHORT CIRCUIT TEST 2 WARNING: Do not probe or disconnect the airbag connector(s) during this test.
- Disconnect clockspring connector C2R115B
- Connect clockspring connector C2LS41H
- Refer to the appropriate service information and install the driver airbag DRIVER AIRBAG MODULE
- Connect the multimeter to clockspring connector C2LS41H terminal 4 and earth
Does the multimeter display > 0V and < battery voltage?
Yes: Install a new steering wheel heater control module
No: Install a new clockspring