DTC P0810-62: Clutch Position Control Error - Signal compare failure: Action
NOTE:
After installing a new rear differential control module, differential locking motor or electric differential, clear the DTCs and calibrate the system by performing routine - On Demand Self Test.
- Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On Demand Self Test and cycle the ignition
- Inspect the differential locking motor connectors for signs of water ingress and pins for damage and/or corrosion
- Refer to the appropriate service information and check the differential locking motor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the appropriate service information and check the differential locking motor position sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- If the fault persists, install a new differential locking motor