Abs Module Logging P0120-81 (SSM74974)
WARNING: This page is about the Range Rover HSE, 2.0L Eng VIN Y, which is a different variant/trim than selected.
Publication date: 2020-08-11Reference number: SSM74974
ABS MODULE LOGGING P0120-81
TECHNICAL SERVICE BULLETIN
Reference Number(s): SSM74974, Date of Issue:
August 11, 2020
| LAND ROVER: | Discovery/L462; Range Rover/L405; Range Rover Sport/L494; Range Rover Velar/L560 |
| SERVICE CATEGORY: | Electrical |
ISSUE
JLR is investigating ABS module logging P0120-81.
CAUSE
During a brake over accelerator event as detected by the PCM, throttle pedal plausibility signal is sent as 0 to the ABS and IPMA module.
ACTION
Please Note - 20MY ONLY
PLEASE NOTE - This action is currently NOT applicable to the following engine variants
- AJ126 - V6 S/C 5.0L PETROL
- AJ133 - V8 S/C N/A 5.0L PETROL
This procedure requires a minimum of Pathfinder 277 loaded or later.
- Connect the JLR approved battery support unit.
- Connect the JLR approved diagnostic equipment to the vehicle and begin a new session.
- Follow the JLR approved diagnostic equipment prompts.
- Select 'ECU Diagnostics'.
- Select 'Powertrain Control Module (PCM)'
- Select 'Update ECU'.
- Follow all on-screen instructions to complete the task.
- When all of the tasks are complete, exit the session.
- Disconnect the JLR approved diagnostic equipment and the JLR approved battery support unit.
A TOPIx update is in progress and will be published shortly which will supersede this SSM.
Thank you in advance for your assistance with this matter.