DTC U2100-51: Initial Configuration Not Complete - Not programmed: Action
- If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
- Using the Jaguar Land Rover approved diagnostic equipment, run application - All-Wheel-Drive (AWD) - Rear Drive Unit Classification Check
- Start the engine. If the fault persists, using the Jaguar Land Rover approved diagnostic equipment, re-configure the all wheel drive control module with the latest level software. Re-run the application - All-Wheel-Drive (AWD) - Rear Drive Unit Classification Check. If the fault persists, check and install a new all wheel drive control module as necessary