DTC U0314-57: Software Incompatibility with Four-Wheel Drive Clutch Control Module - Invalid/Incomplete software component: Action
NOTE:
Re-configuring the all wheel drive control module will automatically re-configure the driveline disconnect control module.
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the left and right all wheel drive control modules with the latest level software
- Refer to the electrical circuit diagrams and check the all wheel drive control module actuator circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the circuit as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On-Demand-Self-Test. If the fault persists, check and install a new all wheel drive actuator motor as necessary, clear the DTCs and retest
- If the fault persists, check and install a new all wheel drive control module as necessary