DTC P3004-31: Driveline Disconnect Control Module - No signal: Action
NOTE:
Re-configuring the all wheel drive control module will automatically re-configure the driveline disconnect control module.
- If available using the Jaguar Land Rover approved diagnostic equipment, select one of the following guided diagnostic concern areas below, or select the guided diagnostic using the available tab
- Powertrain - Transmission and Driveline - Loss Of Traction
- Warning - Messages - 2 wheel drive only - traction reduced
- Using the Jaguar Land Rover approved diagnostic equipment, re-configure the driveline disconnect control module with the latest level software
- Refer to the electrical circuit diagrams and check the power transfer unit power and signal circuits for short circuit to ground, short circuit to power, open circuit, high resistance. Disconnect and re-connect connectors to check for poor connection
- Using the Jaguar Land Rover approved diagnostic equipment, perform routine - On-Demand-Self-Test, repair any issues reported by the test. Clear the DTCs and start the engine
- If the fault persists, check and install a new driveline disconnect control module as necessary. Clear the DTCs and retest
- If the fault persists, check and install a new all wheel drive control module as necessary