DTC B10A2-07 Crash Input - Mechanical failures: Action
WARNING: This page is about a different variant/trim than selected.
NOTE:
The FlexRay wiring harness must not be repaired by making a localized wiring repair. A new wiring harness should be installed.
- Vehicle Conditions to Enable DTC Logging Strategy
- Ignition on for greater than 60 seconds
- Prioritized checks to perform
- Using the Jaguar Land Rover approved diagnostic equipment, check the restraints control module for related DTCs and refer to the relevant DTC index
- Refer to the appropriate system wiring diagrams and check the crash signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, perform a CAN network integrity test. Refer to the appropriate system wiring diagrams and check the high speed CAN bus (chassis) circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the appropriate system wiring diagrams and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the appropriate system wiring diagrams and check the restraints control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary