DTC C200B-01: Steering Shaft Torque Sensor 1 - General electrical failure: Action

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: DO NOT reset the DTCs. Record the diagnostic session and upload to JLR. Failure to follow this instruction may result in warranty claim becoming invalid

Refer to the electrical circuit diagrams and check the security and integrity of the power steering control module torque sensor circuit cable and connectors. Repair or replace circuit(s)/connector(s) as required. Clear the DTCs and retest
Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest. If the fault persists, check and install a new steering gear as required