DTC C0044-54: Brake Pressure Sensor "A" - Missing calibration: Action
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.
- Using the Jaguar Land Rover Approved Diagnostic Equipment, perform routine - Calibrate Pressure Sensor
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check datalogger signal - ECU Power Supply Voltage (0xD111). Refer to the appropriate SYSTEM WIRING DIAGRAMS and check the anti-lock brake system control module power and ground circuits for open circuit, high resistance. Repair circuit as required
- Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest. If the fault persists, install a new anti-lock brake system control module