DTC P0936-64: Hydraulic Pressure Sensor Circuit Intermittent - Signal plausibility failure: Action

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: A new automatic transmission is supplied complete with a new transmission control module. After installing a new automatic transmission, perform routines - Configure New Module (Including Transmission Replacement), Transmission Control Module Adaption.

Refer to the relevant section of the workshop manual and check the automatic transmission fluid level and condition. Rectify any fluid leaks and top up as necessary. Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and perform a road test using all gears. If the fault persists, install a new automatic transmission