DTC P0932-14: Hydraulic Pressure Sensor Circuit - Circuit short to ground or open: Action
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
After installing a new transmission control module, perform routines - Configure New Module (Without Transmission Replacement), Transmission Control Module Adaption.
- Refer to the electrical circuit diagrams and check the pressure sensor signal circuit for short circuit to ground, open circuit, high resistance. Repair the wiring harness or install a new pressure sensor as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new transmission control module