DTC P07E4-64: Unable to Engage Park - Signal plausibility failure: Action

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: After installing a new valve block, perform routines - Transmission Valve Block, Transmission Control Module Adaption.

Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, check that the park position sensor mounting is secured at the correct torque (5.5Nm) and rectify as required. To gain access to the park position sensor mounting, it is first necessary to remove the ten mounting bolts of the main control valve body and lift the valve body unit from the transmission housing (refer to Automatic Transmission, Removal and Installation, Main Control Valve Body, steps 1 to 5). The park position sensor is located inside the main casing, adjacent to the electrical connector. The sensor is secured to a boss in the main casing with a screw
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new valve block