DTC P0710-27: Transmission Fluid Temperature Sensor "A" Circuit - Signal rate of change above threshold: Action
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Automatic transmission fluid temperature sensor resistance specification is 1 kΩ at 25°C.
- Disconnect the vehicle wiring harness from the Transmission Control Module (TCM). Refer to 418-02 - Wiring Harnesses - General Procedures. Reconnect the vehicle wiring harness, clear the DTCs and retest
- If the fault persists repair or replace the vehicle wiring harness as necessary and retest
- If the fault persists, remove the internal wiring harness from the valve block assembly. Refer to 418-02 - Wiring Harnesses - General Procedures. Reinstall the internal wiring harness, clear the DTCs and retest
- If the fault persists repair or replace the internal wiring harness as necessary and retest
- If the fault persists, contact the technical support desk for further assistance