DTC P0894-07: Transmission Component Slipping - Mechanical failures: Action
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Land Rover Range Rover Evoque, 2018 Land Rover Range Rover Evoque, 2017 Land Rover Range Rover Evoque, 2016 Land Rover Range Rover Evoque, and 2015 Land Rover Range Rover Evoque. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The All Wheel Drive System Pump Bleed routine must be performed after all rear drive unit hydraulic system repairs.
- Refer to the relevant section of the service information and check the rear drive unit hydraulic fluid level
- Check the rear drive unit hydraulic pipes for damage/blockages
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the all wheel drive control module with the latest level software
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new power transfer unit. For additional information, refer to: TRANSFER CASE - INGENIUM I4 2.0L PETROL, VEHICLES WITH: ACTIVE DRIVELINE .
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new all wheel drive control module.
For additional information, refer to: DIFFERENTIAL CONTROL MODULE (Removal and Installation).