DTC B102A-64: Flame Sensor - Signal plausibility failure: Action

NOTE: The fuel fired booster heater assembly contains many serviceable components. It should NOT be necessary to replace the entire fuel fired booster heater unit to rectify this fault

Refer to the appropriate system wiring diagrams and check the flame sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the circuit or install a new flame sensor located within the fuel fired booster heater as necessary
Using JLR approved diagnostic equipment, clear the DTCs and perform routine - Auxiliary Heater (AHCM) Activation Test (0x900A). This will operate the fuel fired booster heater for 15 minutes. Note that the routine should be started only when the engine is cool. The routine should be performed with the engine running and with the climate controls set to maximum heat and maximum fan. Repeat the routine again if smoke continues to be visible from the fuel fired booster heater exhaust pipe or from the area surrounding the fuel fired booster heater