Possible Causes
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Monitor description. If the driver is pressing the accelerator pedal and the vehicle is accelerating and the brake pressure is low both brake pedal switches should be off/inactive. If the switches are on/active in this condition then the brake pedal switches have failed and the DTC is set
- This DTC is set when the powertrain control module measures a signal that remains high when transitions are expected.
- Brake pedal switch detached from mounting bracket/pedal box while electrically connected
- Brake pedal switch mounting position incorrectly adjusted
- Brake pedal switch plunger partially stuck out
- Brake pedal switch 1 circuit open circuit, short circuit to power, short circuit to ground
- Brake pedal switch 2 circuit open circuit, short circuit to power, short circuit to ground