DTC P0328-22: Knock/Combustion Vibration Sensor 1 Circuit High Bank 1 or Single Sensor - Signal amplitude > maximum: Action
WARNING: This page is about a different variant/trim than selected.
- Refer to the appropriate system wiring diagram and check knock sensor circuit for short circuit to power
- Measure knock sensor circuit for correct resistance
- 1 to 1.8 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check for abnormal engine noise that may corrupt the knock sensor signal
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest
- Check and install a new knock sensor as required