DTC C1A05-26: Left Rear Height Sensor - Signal rate of change below threshold: Action
WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The vehicle ride height must be calibrated if a new height sensor is installed or any height sensor fixings loosened/tightened
- Using the manufacturer approved diagnostic system, check datalogger signal - Left Rear Height Sensor (0x3B72). Refer to the appropriate system wiring diagrams and check the rear left height sensor circuits for short circuit to ground, short circuit to power, open circuit, high resistance
- Install a new rear left height sensor