Climate Control Assembly: Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
NOTE:
Make sure that the gear selector lever is in position N before removing any components.
- Refer to Floor Console Upper Section article.
- Torque: 2.5 Nm
- See figure
- See figure
- Torque: 2.5 Nm
- Torque: 2.5 Nm
- See figure
- See figure
CAUTION:
When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.
NOTE:
LHD illustration shown, RHD is similar.
NOTE:
Remove in the sequence shown.
NOTE:
To install, reverse the removal sequence.
CAUTION:
When installing the lower locating tang of the trim panel, make sure the floor console is not damaged. If necessary protect the surrounding areas using masking tape.
NOTE:
Remove in the sequence shown.
NOTE:
To install, reverse the removal sequence.