BLUETOOTH Module (Tel): DTCs

BLUETOOTH MODULE (TEL) DTCs

DTC	Description	Possible Causes	Action
B1D79-84	Microphone Input - Signal below allowable range	The 'Receive Audio over MOST Test' failed and means that the audio received at the microphone detection point is too low Microphone fault Harness/connector fault Integrated head unit (IHU) fault	Check the operation of the microphone. Refer to the electrical circuit diagrams and check the microphone (MIC) circuits. Renew/repair as necessary. Refer to the warranty policy and Procedures information if a module is suspect.
U1A00-88	Private Communication Network - Bus off	Internal communications failure	Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and Procedures information if a module is suspect.
U2001-9A	Reduced System Function - Component or system operating conditions	Bluetooth error - system over-temperature	Allow the system to cool, clear the DTC and check /monitor for re-occurrence. If DTC re-occurs suspect the module. Check and install a new module as required. Refer to the Warranty Policy and Procedures information if a module is suspect.
U201A-54	Control Module Main Calibration Data - Missing calibration	Local configuration file is missing (not loaded) in the control module	Configure the module using the manufacturers approved diagnostic system (file download may take several minutes).
U3000-44	Control module - Data memory failure	Bluetooth Module RAM fault (data memory failure leading to possible corrupt local configuration file)	Configure the module using the manufacturers approved diagnostic system and download the local configuration file. Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and Procedures information if a module is suspect.
U3000-45	Control module - Program memory failure	Bluetooth Module ROM fault (data memory failure leading to possible corrupt local configuration file)	Configure the module using the manufacturers approved diagnostic system and download the local configuration file. Clear the DTC and retest. If the problem persists, renew the Bluetooth Module. Refer to the warranty policy and Procedures information if a module is suspect.
U3000-54	Control module - Missing calibration	MOST not configured correctly - incorrect voice language installed	Check and amend the Car Configuration File in the Information and Entertainment Control Module using the manufacturer approved diagnostic system.
U3000-56	Control module - Invalid/incomplete configuration	One or more of the received car configuration file (CCF) data parameters is deemed to be invalid	Check and amend the Car Configuration File using the manufacturer approved diagnostic system.
U3003-16	Battery Voltage - Circuit voltage below threshold	Battery voltage below threshold	Check vehicle battery and charging system. Refer to the relevant instructions in the workshop information. Refer to the electrical circuit diagrams and check the power supply circuits to the module.
U3003-17	Battery Voltage - Circuit voltage above threshold	Battery voltage above threshold	Check vehicle battery and charging system. Refer to the relevant instructions in the workshop information. Refer to the electrical circuit diagrams and check the power supply circuits to the module.