LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  2. Remove the wheel and tire.
  3. Disconnect the anti-lock brake system (ABS) sensor electrical connector.
    • Release the wiring harness retaining clip.
    GJ0014570
  4. Release the wheel speed sensor from the wheel knuckle.
    • Release the wiring harness.
    • Remove the retaining bolt.
    GJ0014571
  5. Remove the wheel speed sensor.
    • Release the wiring harness from the 4 clips.
    GJ0014572
scientia non olet · About LEMON Manuals