Steering Angle Sensor: Removal
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. Refer to Specifications .
- Remove the driver side closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.
- Disconnect the steering angle sensor electrical connector.
- Disconnect the steering column intermediate shaft from the steering column.
- Note the fitted position.
- Remove the special bolt and discard the nut.
- Remove the steering angle sensor.
- Remove the 3 Torx screws.