LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> LR4 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Power Steering) >> Power Steering >> Removal And Installation >> Power Steering Control Valve Actuator >> Installation

Power Steering Control Valve Actuator: Installation

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the working surfaces are thoroughly clean to avoid contamination of the sensitive hydraulic components.
  1. Clean the component mating faces.
  2. Install a new filter to the steering gear.
  3. Install new seals to the actuator.
    4. NOTE: Align to the position noted on removal.
  4. Install the actuator.
    • Tighten the new Torx screws, evenly and progressively, to 3 Nm (2.2 lb.ft).
    • Connect the electrical connector.
  5. Install the wheel and tire.
    • Tighten the wheel nuts to 140 Nm (103 lb.ft).
  6. Connect the battery ground cable. Refer to Specifications .
  7. Refill and bleed the power steering. Refer to Power Steering System Filling and Bleeding .
scientia non olet · About LEMON Manuals