Rear Window Wiper Motor: Installation
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rubber insulators.
- Install the rear wiper drive spindle seal.
- Clean the component mating faces.
- Install the rear window wiper motor.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Connect and secure the electrical connector.
- Install the trim panel retaining plate.
- Tighten the nuts to 6 Nm (4 lb.ft).
- Install the liftgate glass wiper motor trim panel.
- Carefully secure the clips.
- Install the rear wiper arm. See REAR WIPER PIVOT ARM .
- Connect the battery ground cable. Refer to Specifications .