LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transmission/Transaxle External Controls >> Automatic Transmission/Transaxle External Controls (Vehicles With: AWF21 6-Speed Automatic Transmission) >> Removal And Installation >> Selector Lever Knob, Boot And Bezel >> Installation

Selector Lever Knob, Boot And Bezel: Installation

  1. See figure
    GJ0020780
  2. See figure
    GJ0020781
  3. See figure
    CAUTION: Take care not to touch the printed side of the printed circuit board (PCB).
    GJ0020776
  4. See figure
    CAUTION: Make sure the selector lever button is depressed when installing the selector lever knob. Failure to follow this instruction may result in damage to the selector lever assembly.
    CAUTION: Make sure the ribbon cable is routed in front of the selector shaft.
    GJ0020782
    5. NOTE: Make sure the cut out on the locking ring faces towards the front of the vehicle.
    • Install the locking ring.
    GJ0020783
    • Secure into the 3 clips.
    GJ0020784
  7. Switch the ignition on.
  8. Position the transmission selector lever into PARK.
scientia non olet · About LEMON Manuals