Maintenance Service Reminder Reset - Procedure 03

NOTE: If vehicle distance is the trigger for the Service Interval Indicator, 'SERVICE' will be displayed in the odometer accompanied by a distance qualifier (either 'MILES' or 'KM' depending on the instrument cluster specification). A distance counter will also be displayed in the top Right Hand (RH) corner of the odometer. If the point at which a service is required is passed, the counter will display a negative value. When activated, the Service Interval Indicator is displayed for 5 seconds when the vehicle enters power mode 6.

If time is the trigger for the Service Interval Indicator, 'SERVICE' will be displayed in the odometer accompanied by a clock symbol. A counter will also be displayed in the top RH corner of the odometer. If the point at which a service is required is passed, the counter will display a negative value. Again, when activated the Service Interval Indicator is displayed for 5 seconds when the vehicle enters power mode 6.

If both the distance and time triggers are activated, the Service Interval Indicator will display the distance information for 5 seconds, followed by the time information for 5 seconds.

Reset Procedure:

When a service has been carried out, the Service Interval Indicator will need to be reset. This can be done using a Land Rover-approved diagnostic system or (on some models) the following manual reset procedure.

Press and hold the trip reset button with the vehicle stationary and in a power mode less than 6.
While holding the trip reset button, enter the vehicle into power mode 6.
Release the trip reset button within 10 seconds of entering power mode 6.
If the manual reset mode has been successfully entered 'dISt' or 'DATE' will be displayed in the odometer, depending on which trigger has been activated.
To clear the 'dISt' trigger, press and hold the trip reset button for more than 5 seconds, within 10 seconds of entering the manual reset mode. If successful, 'RESET' will be displayed in the odometer for 5 seconds. If the date trigger has not been activated 'END' will then be displayed in the odometer.
NOTE: The distance trigger will not reset if the distance the vehicle has traveled is less than 20% of the next service interval value.
If the date trigger has been activated, 'DATE' will be displayed in the odometer. To clear the trigger, press and hold the trip reset button for more than 5 seconds within 10 seconds of 'DATE' being displayed. If successful, 'RESET' will be displayed within the odometer for 5 seconds followed by 'END'.
The odometer will now exit reset mode.