DTC P0706-68: Transmission Range Sensor A Circuit Range/Performance - Event Information: Action
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Gear Selector Sensor Calibration routine must be performed after installing a new automatic transmission or transmission control module, or after removing and installing the existing transmission control module.
- Refer to the relevant section of the service information and adjust the gearshift mechanism cable
- Using the manufacturer approved diagnostic system, perform routine - Gear Selector Sensor Calibration
- Using the manufacturer approved diagnostic system, clear the DTCs and retest. If the fault persists, install a new transmission control module