DTC C2007-01: Right Motor - General Electrical Failure: Action
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
- Refer to the appropriate system wiring diagram and check the right electric park brake actuator circuit between electric park brake control module pin 12 or 27 and electric park brake actuator pin 1 or 2 for open circuit, disconnected
- Switch ignition off and on. Apply and release the electric park brake using the electric park brake switch. Clear the DTC and re-test. If the fault is not reset, suspect electric park brake control module fault. Install a new electric park brake control module as necessary