DTC C0064-28: Roll Rate Sensor General Signal Failures - Signal bias level out of range/zero adjustment failure: Action
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
- Carry out the roll rate sensor calibration routine using the manufacturer approved diagnostic system. Clear DTC and retest
- Refer to the appropriate system wiring diagrams and check roll rate sensor circuit for open circuit. Repair circuit as required. Clear DTC and retest
- If fault persists, check and install new roll rate sensor as required